Selestia by Kaloud

OnTap to rest the light

Brightness80%

Experiences

Your light knows six colours and one channel of brightness.

Your light

Respond to draw

Reacts when someone pulls the hose

Efficiency

Trims about 25% of the lighting energy

Night shift

Warm, dim light that is easy on your eyes after dark

Session timer

10 min is Kaloud's recommended warmup time before smoking, for the bowl to bloom. The light keeps this timer itself, so it runs with your phone asleep. It signals when time is up; it does not turn the light off.

Sleep timer

Fades the light out after a set time.

Keep the timer on the light

Arms the light's own shutdown clock alongside the sleep timer, so it still powers down with your phone asleep. Once set it can only be pushed back, not cleared. Not every light carries this.

Auto off when idle

Rests the light after this long with no activity

Notifications

Alerts you if the light disconnects or a timer ends while you are away

Home preset

Apply on connect

Press this look onto every light automatically

Connection

Manage

—

Settings on the light

Your light cannot report what it is holding, so the app writes every setting to it on connect and says exactly what it sent. Press this any time you want to be certain.

Nothing sent yet this session.

Protocol

—

Battery

—

Firmware

—

Capabilities

—

Service map

Write timing

Measures how fast this light really accepts commands. The result sets how smooth every animation can be. Takes about a minute; the light will pulse.

Hardware check

Drives your own light through everything the app promises and asks you what you saw, because the light cannot tell us. It proves whether off is really off on your firmware, learns which way round the power flag runs and remembers it, checks the charge, and times the sleep timer against the clock. Takes about three minutes. Keep the light in view.

Blackout test

Steps the light down through the lowest values, holding each for three seconds and announcing it. Watch the light and note the first value where it is genuinely dark.

Colour calibration

Measures what colour each of the six patterns really is, using this device's camera. The app drives your light and watches it at the same time, so the colours in this app come from your own hardware instead of from a specification that leaves four of the six unconfirmed.

Do this in a dark room. Hold the camera about 20 cm from the light with nothing else bright in frame. Takes about a minute.

Mapping audit

Writes every candidate value and reads back what the firmware actually stored, so the brightness and pattern mapping is derived from your light instead of from the specification. Takes about two minutes. Copy the result back to Claude.